This speaker bracket replacement exists because of my unlovable, grumpy, fat, wreckmaker cat that broke it.
Made to look as close as possible to the original bracket, with added strenght : full width back support insted of the only two small ridges and I filled the hole. 

• Printed in 0.2mm layer height just fine.
• No support needed.
• Bed adhesion could be usefull if your setup isn't perfect.
• Small piece so no need to have a high infill, 20% is more than enough.
• Printed with 4 walls and 5 tops/bottoms but that dosen't matter much.