Just as my previous container with all those benefits, but this one has better volume to mass ratio. Basically you get more useful space for the same amount of filament.

Designed to be printed with a 0.8mm nozzle. Should work fine with any smaller ones. Just make the layer height ⅓ of the nozzle diameter or lower.

Also scalable to 75% for a 0.6mm nozzle and to 50% for a 0.4mm nozzle. Would not recommend scaling down more than that due to engineering reasons.

To print a cap, turn it upside down.

Feel free to remix it if you can make it better or whatnot.