I created my own HyperCube X Carriage for mounting an E3D Hemera.

It is based on the original X carriage by Tech2C [1] as well as the remix by arturslab with the integrated belt tensioner [2].

I also have included the FreeCAD file in case you want to remix it.

Note that the installed version on the two images is the previous version which had the following issues:

• Belt tensioner: holes to feed belts through were to small, was hard to push the belts through.
• Mount of x endstop: to location of the x endstop caused issues when homing.

The v0.5 should have fixed these issues. But I have not tested it.

------

[1] https://www.thingiverse.com/thing:1752766

[2] https://www.thingiverse.com/thing:2013475