This is a really simple tool that I've found useful in eliminating some messing around when designing something to fit a physical object with a given amount of slack.

For example, say you have a metal rod or a hex bit from a drill that you want to "fit" into your 3D printed object. You measure the item with calipers, which gives you the size for the design, but you're not too sure what the actual "fit" will be like when it's printed out.

Sometimes you want a loose fit, which will be loose enough to allow the item to slide freely, but not so loose that it will wobble around in the hole. Sometimes you want a tight fit, so the item will go into the hole, but not come loose without some small amount of force (like the "grip " between Lego bricks). And sometimes, as with screws, you want it to be small enough that the item won't quite fit into the hole, but the hole is large enough to allow the screw to "bite" into the plastic without destroying things in the process.

I generally have a "feel" for these tolerances now with my printer, but these blocks give a really quick way to test and have some peace of mind, and real confidence that the printed item is going to do the job.

The OpenSCAD file allows the generation of blocks of arbitrary sizes, though the provided STL files will probably meet most needs.

Each row of 10 holes has a label at the end that indicates the "base" size in mm for the holes of that row. Each hole is 0.1mm larger than the one to the left, starting at 0.0mm larger (i.e., the "base" size) and going up to 0.9mm larger at the right-hand end.

By messing with the parameters in the OpenSCAD file, you can quickly generate a custom block with rows of the desired thickness, hole size, and number of sides for the holes.

Some notes if you're using the OpenSCAD to create your own blocks:

• I'd avoid going crazy and, for example, try printing a single block that does every hole size between 0mm and 15mm; it will take ages to print, and you'll use up unnecessary filament because of the spacing around the holes. Four rows in a block is probably as far as you want to push it for print time and effective use of your roll of plastic.
• You can customise the number of sides for the holes with the - you'll probably just want circles or hexagons, but if you want you can do triangles or octagons or whatever you like. Just bear in mind that it's the hole diameter you're working with, so if you do squares with a diameter of 5mm, you won't get squares with 5mm sides, you'll get squares that are 5mm diagonally between opposite corners (the diameter of the circle which would contain the square).

Print Settings

Printer Brand:

Anet

Printer: 

A8

Rafts:

No

Supports: 

No

Resolution:

0.2mm

Infill: 

20%

Filament: 3DFillies PLA Orange

Notes:

These can be challenging to print if you have any problems with initial layer adhesion - make sure you have that sorted out before starting, otherwise, you'll might find that the initial hole outlines on the base layer pop off and come loose. This happened to me when I tried printing one out on a particularly cold day and had forgotten that I had the window open to let some fresh air into the room. It doesn't make the print "useless", but the bottom side of it can get messy.