When I have my morning coffee, I prefer to sit with the living room table to my right.

My coffee mug is held in my left hand, so I would like to design a small table that is 50 cm high and provides adequate support for it. 

My first attempt was to use a design that connected the legs of this table with glue and an insert piece. After assembling, I found that the design is poorly considered from an assembly standpoint and that the glue might leave some marks on the leg components.

The second design has a better way of connecting the parts of the legs and you can change each one individually or disassemble some of them to suit your needs.

Because of its versatility and ability to be quickly and easily assembled, the finished design can be altered to shorten it if necessary and to alter how the legs attach to one another.

--------------------

for this table you will need:

• 3x M4x20 Countersunk Screw

• 6x M3x10 HEX head bolts

• 3x M4x10/8/6 Insert (the length of the insert can be from 6-10mm)

Print instructions:

• Plate
  • Layer hight: 0.3 mm
  • Infill pattern: Gyroid
  • Top fill pattern: Concentric
  • Infill density: 5%
  • --No support needed--
  • Material: PLA ( ~154 [g] )
  • Remove the skirt setting, this part uses the full area of the bed and a skirt may make it too big to fit the bed.
  • for a better grip of the insert in this part, it's recomended to reinforce the locations of each insert with cylinder modifier with more Perimeters as shown in the picture.

---------------------

• Legbase
  • Layer hight: 0.3 mm
  • Infill pattern: Gyroid
  • Infill density: 7%
  • Support type: Organic (only for the connection area overhangs)
  • Material: PLA ( ~151 [g] )

---------------------

• Leg2 & Leg1
  • Layer hight: 0.3 mm
  • Infill pattern: Gyroid
  • Infill density: 7%
  • Support type: Organic (only for the connections area overhangs)
  • Material: PLA ( ~169.3 [g] for all 3 legs )

---------------------

• MidSupport
  • Layer hight: 0.3 mm
  • Infill pattern: Grid
  • Top fill pattern: Octagram Spiral ( you can be creative with this settings )
  • Infill density: 5%
  • Support type: Organic
  • Material: PLA ( ~50 [g] )

---------------------

• LegPad (Optional)
  • Layer hight: 0.3 mm
  • Infill pattern: Grid
  • Infill density: 5%
  • --No Support needed--
  • Material: FLEX ( ~7 [g] )

---------------------

If you want to see how I print it you can check out the .3mf files.

Enjoy ;-)