A clip that can be stuck to the underside of a desk or table that can hold the cord of a surge protector (or any other cord of that size) so that the cord doesn't sit on the floor. I used 5 clips to hold the cord of the surge protector.

It is made for cords that are about 0.373 inches (9.47 mm) in diameter. I made it to go with the ACCO Power Strip.

Press the cord through the opening of the clip. Place 3M VHB tape on the large flat area of the clips and stick them to a flat surface.

I printed them on the Ultimaker S5 with breakaway support material. I printed them on their sides. I used 0.2mm layer height and 20% infill.