Do you have a stylish tissue paper box case that just became useless because tissue box manufacturers changed the size of the box, now that box won't fit and you put the tissue paper and now it's impossible to pull a piece without tearing them all up? Now the time is over! Don't throw away your lovely case!!

This model is very easy to print, and finishes in about a couple of hours!

Sizing

Bewear that this is designed around Japanese tissue box standard (I tested with Kleenex but of Japanese market version, so I'm not sure the size standard is compatible with American one for example, not to mention that of any other countries).

• Outer demensions (Make sure two of this fits within your case)
  • Width: 124mm; 4.88in
  • Depth: 70mm; 2.76in
  • Height: 65mm; 2.56in
• Inner dimensions (This is where stack of tissue paper fits)
  • Width: 122mm; 4.80in
  • Depth: Minimum 68mm x 2; 2.68in x 2 (Depends on the lengthwise demension of the enclosing case)
  • Height: 62.5mm; 2.46in

Overhang

The top part has a little bit of overhang that goes up to about 31mm (1.20in). I had no problem with PLA on Prusa mini, and I am wildly assuming that it tends to be alright for the modern printers in most cases, but if sagging was the concern, please bewear, as I didn't include  neither alternative model nor file with supports configured.