Phoenix ashtray:

• For personal/travel usage
• With groove for sealing rubber (For a regular hair band with a diameter of 4 cm)
• Bayonet thread

Print Settings: 🖨⚙
◦ Material:                  ASA
◦ Flow rate:                96% (But first layer at 110%)
◦ Nozzle diameter:    0.6 mm (recommended)
◦ Layer height:          0.2 mm
◦ Perimeters:             3 (with 0.4 nozzle use 4 perimeters)
◦ Solid layers:            Top: 6, bottom: 4
◦ Infill:                         Honeycomb at 30%
◦ Bottom Infill:           Hilbert Curve
◦ Brim:                        4 mm
◦ Print speed:             30 mm/s
◦ Print orientation:    As in STL files
◦ Support:                  No

Benefits of printing: 
◦ Chamber
◦ Heated chamber at 45°C, Bed 90°C
◦ Smooth PEI bed plate, 3DLack
◦ Z offset -0.1 mm (for printing the first layer under moderate pressure)

If you don't have any of the benefits, you can use ASA_anti-warping_triangles, in PrusaSlicer/Superslicer set precise alignment (for proper alignment of objects on the print bed) and use a 4mm brim on everything.


ℹ Note: The Phoenix_Bottom model includes a groove (at the end of the bayonet thread) for inserting a sealing rubber band. Using tweezers, attach and align (by sliding the tweezers along the edge of the groove) the rubber band into the groove.

(With a rubber band, you will get a full anti-smell seal).