A print born of necessity, these models allow you to keep your remotes mounted in an easy-to-find spot - Hanging off the light switch! 

The caddy has legs that slip under the switch plate. 

Steps to install: 
1. Unscrew switch plate from wall
2. Position model's legs over the switch plate mounting holes
3. Screw switch plate in, going through model's holes and into the mounting holes. 

That's it!

There is a version for traditional switches and rocker switches - be sure to use the right one. 

The rocker version's legs are 100mm apart center to center. This ended up being slightly too wide for mine but I was still able to make it through by angling the screw enough to get an initial bite and then leveraging it up slightly. 

The switch version's legs are 60mm apart center to center. Perfect fit for my switch. 

Printing note: I couldn't figure out any better way than printed flat on its back with “Normal (auto)” supports. 

Please be sure to upload your make! I would love to see this come in handy. Will upload full CAD file for modifications at a later date.