Almost fully 3D printable Xceed driver from Super Hyperion!
All you need is a spring which can be compatible or taken off from damaged/knock-off driver and 3 screws.

You can choose if you want a fully plastic tip or make yourself a rubber one (for example you can use my cutoff for automatic pencil rubber and glue it to the smaller part 5).

3 screws are needed to connect it together (one inside for the tip and two for enclosure).

Screw it tight so it can perform as the original one.

Actually you can put anything for the tip if it's a cylinder with 5 mm diameter and about 4.5-5mm length.

Anet

A8

No

Yes

0.1

100%