I needed a way to wrap up a lot of rope for a bike lift. The ceiling was so high that I ended up with way more rope than the little included cleat could handle. So I threw together a quick split design.

Print two. Separate to the desired width. Screw in (to a stud or something else that's quite solid). Wrap yer rope. Yee haw!

Print Settings

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2mm layer height

Infill:

Notes:

Print with one of the large sides facing down. Will be strongest and require no supports.

Note that using this orientation, it will split down the middle if you use a sloped-head wood screw, as the head of the screw will act as a wedge. If you do use a sloped-head screw, be sure to add a washer. I used #8 cabinet screws with standard M4 washers.

Category: Organization