A collaboration between thatch and myself. A lightweight layer fan that fits both E3D V6 and Volcano length heater blocks. Inspired by Tom114's remix of Prusa MK2 fan.

Everything should print without supports, however there is a trap nut on the blower bracket that may require them for your machine. The blower bracket can be slid up and down along a half dovetail to the desired height before tightening into place.

Requires:

• 50mmx15mm radial fan
• E3D cold zone fan and plastite screws
• (1) M3x35mm cap head screw (longer can work)
• (1) M3x20mm cap head screw (longer can work)
• (2) M4x20mm screws for the blower
• (2) M3 nuts

Print Settings

Printer:

Prusa MK2

Rafts:

Supports:

Doesn't Matter

Resolution:

Infill:

25%

Notes:

How I Designed This ===================

Onshape

Category: 3D Printer Parts