Front probe mount for Geeetech 3dTouch auto level probe. It will probably work for the BLTouch as well.

Note that you need to be running a rear mounted cooler (such as the cobra) to use this probe mount. You will also need customised firmware.

The design requires the following hardware to mount:

• 2 x m3 bolt 12mm
• 2 x m3 bolt 8mm (min, longer is fine)
• 4 x m3 nut

The probe offsets in Marlin firmware are:

#define X_PROBE_OFFSET_FROM_EXTRUDER 38
#define Y_PROBE_OFFSET_FROM_EXTRUDER -48
#define Z_PROBE_OFFSET_FROM_EXTRUDER -1.6

Wanhao

Wanhao Duplicator i3 Plus

No

No

0.2

50%

Print with the flat surface face down.