So following on from a reddit post I saw a while back where someone had made a 3d printed version of their fridge as a magnet for a competition (maybe Thingeeverse or here on pintables???) I made this one that matches my wife and I's Smeg retro style fridge.

The only extra bits you need to find are some magnets to glue in.
The holes are 22mm x 2.5mm.
I have some 16mm x 3mm magnets in there and the extra depth helps you pull the magnet off the fridge.
I'm not sue if you were to use 2/2.5mm dep magnets if it'd come off as easy.

All printed in pla luckily at the time I already had loaded up the silver for another project so I printed out the logo and handle then the main body.

Assembly wise the hot tip is to lay out the logo as you want to see it then use some low tack tape on the front face to hold them in place.
Flip the tape over and super glue lightly the underside of the logo.
Then use the tape to arrange the whole lot at once where you want it on the body of the magnet.

Be fairly sparing with the superglue as you can see for the image of the magnets if you go overboard it can be a bit average looking.
Luckily for me it was only on the backside so I didn't worry about re printing.

The handle is pretty straight forward as are the magnets.