I carry a pad of paper at work, but it always gets torn and mangled in my pocket long before it is filled up. So this is an attempt to make a slim sleeve that will keep the pad from getting destroyed.

This should fit any standard 3" x 5" top coil pad of paper.

Printing:

Orient with the opening up, and the long edge along the axis the table moves, if applicable.

No supports are needed but you should turn on Experimental>Make overhangs printable in Cura. (For some reason I couldn't put a fillet in that one corner in FreeCAD.)

Print with three walls and there will be barely any infill.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament: Sunlu PLA Black

Category: Office