This a remix of a great thing made by Mag-net:

• the model is 20% smaller.
• Cut off the arm at the elbow, so less supports to print full length. It reduced a lot of printing time.
• To forearm attached a hand, to immediately, as one model print out.

You'll need to add supports based on your own opinion. I printed with PLA and supported only the shoulder in the main model part.

Note: Thingiverse still makes ugly previews without saving proportions. See the originals for better experience.

Creality

Ender 3

No

Yes

nozzle 0.4, layer 0.15

20%

I used a different acrylic paints: glossy black for dress, metallic black for mantle, raspberry matt as a blood, "flesh" matt color for bones and pearl blue for eyes. No lacquers cause it turned too complicated to make the glossy dress at the same time with a matt blood.