This is a mount for most small cameras that fits the AR Drone 1.0. I use a SWANN Freestyle Camera but most of the mounts out there are only for the GoPro brand. I left several gaps to mount your camera on. You will need a 1/4-20 (1/4" diameter, 20 threads per inch) screw and maybe a washer or 2 to actually fasten the camera on with.

Of course the added weight will shorten your flight time but it is well worth it to get the 1080p footage without having to buy the 2.0 drone. Also my Tablet has a bad habit of not recording and saving every now and then so this solves that too.

At this time i want to add a little length to the bottom of the arms to better fit the screw that needs to be added but at this time it flies great.

And thanks to Makerware Preview> It will print in about 3.5 hours on low resolution with PLA.

UPDATE: In this version my SWANN either weighs to much or is out of balance. Also i made the pins a little to long. I really want this to work so look for updates and if you want to fix it upload remix.
Thanks for checking it out.

print plate and pins. The pins are a little longer then the original so i suggest to point them out word so that you can fit your camera.

Add a 1/4-20 (1/4" diameter, 20 threads per inch) screw and nut. I am using a short quarter inch with a few washers and no nut but that could change at any time.