Loading the battery mag on YouTube

Print settings
Layer height 0.2mm, wall speed of around 50 mm/s. NO cooling (as low as possible).

Spring
1. aaa6_mag_spring should be printed in PETG.
2. aaa6_mag_spring can be stretched or compressed manually if needed.
3. Z-seam on aaa6_mag_spring should be placed in the corner.

Case
1. The aaa6_mag_case may be printed in PETG, though I recommend PLA due to its rigidity
2. Cooling as low as possible for aaa6_mag_case. This will ensure the best layer adhesion.

No special settings for aaa4_vase_mode

Fusion 360 file is added, you may change the dimensions to your liking. Issues may occur because of fillets, make sure to adjust them.