You know the age old problem - You want to build a bed out of scaffold boards, but you are cack at the following:

1) Measuring things;
b) Using a drill;
iii) Consistent lists.

But you have a 3D printer...

FEAR NOT, Stu has got your back. Hole Guide Part 1 is designed to use a 25mm flat blade to put a hole through a scaffold board, and then a 10mm drill bit to drill a hole in the end which goes through the middle of the 25mm hole.

Part 2 is designed to fit over the end of a second board and let you drill a companion 10mm hole. All you then need to do is bolt it up, and you are halfway closer to not sleeping on a mattress on the floor.

SCADs are included so you can remix them for any hole/wood you might have.

Print instructions

I personally used 0.2mm and roughly 30% infill...but i'm certain that part isn't all too important. You will need to support the guides however.

When I printed them, I oriented a flat side down. I'd suggest you do the same!