A simple L-bracket for hanging the PSU from an Ender 3 v2 underneath the table of a Lack enclosure.

I made it thick enough to hold the PSU without too much wobble, but thin enough that you can screw the factory cover back overtop to help camoflage it and make it look a lot more finished.

2 print quite quickly and it's a nice way to keep the PSU out of the way.

Creality

Ender 3

No

No

.2

20

Note - the L-brackets go as shown onto the wide, flat part of the PSU. If you want to re-install the factory metal cover like I did, you flip it around and just use the factory screw holes which in these pictures are on the bottom.