This is actual working suspension for the Plane Print Super Tucano that replaces the existing Solid suspension and so far works well but your results may vary...

So what do you need.....
-You should have some left over 8X6mm Hollow carbon tube and a 6mm carbon rod, if not you only need about 200mm of each. Sadly I did not measure the exact length before securing them....

2mm m2 screws 12mm X 3 and 15mm X 6
0.8mm -1mm Piano/spring steel wire to make a spring by wrapping it around a 2.5mm screwdriver ( the spring from a pen will not work !)

Printing:

100% infill for everything
01.mm layer height and 3 wall lines thick (yes it takes longer but its worth it)

I Printed them out of Esun PLA plus but you can certainly print it from something else.

ender 5

No

No

200

100