Hi all,

I'm using this to mount my Pi Zero and a HyperPixel 4.0 to my printer.

The Bracket I used to mount it on the printer is available in the Fusion file, but it's not very sturdy, so it's probably best not to use it to be honnest.

I should probably redesign it with a bit more clearance since when tight, the screen is pushed a bit, so BE CAREFUL!!!!

The two holes at the back are for mounting. Otherwise, I use 20mm M3 bolts as that should screw in on the front plate without too much trouble.

There you go! And remix it away if there's anything wrong with it! Cheers!