A set of new vases for your printing pleasure.

The files are solid and must be printed in single wall vase/corkscrew mode.

I use 2 or 3 bottom layers and zero top layers.

The files are 120mm tall (<~5"). You should scale them to the size you want according to your patience level.

I used ABS at 245/110C, .28-.33mm layers using S3D, but use whatever you like.

Note that the short 4th piece in the photo is actually from the BublVase1 file, but the power went down during the print job. Not intentional, but I often recommend printing partial prints to make bowls from vases. Some look great both ways.

Category: Sculptures