Remixed this. Few changes:

1. added about .75 mil of height. The original is a tight fit and holds with friction, problem is it stretches a tad and the vertical bars on the face "warp" inwards. Not a big deal, it just bothered me.

2. pulled face forward about 1.75mm (after the drop down) to make room for a camera butter ND stick on filter.

3. Point two caused the corners of the mount to show in a superview frame, so I cut out the corners.

4. points one and 2 made the session fit a little too losely for my likeing and it was no longer a trustworthy friction fit. Added a slip on band to help hold it all together. You can always use a rubber band, but, meh.

5. point 4 added about 1.5g, so I cut a square out of the back to reduce weight.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.16

Infill:

Filament: SainSmart TPU Why

Notes: