This was an attempt to make a waterproof case for my Olympus camera. This case should fit Olympus FZ82.

I suggest printing it with at least 4 perimeters and 60% infill, then treating it with epoxy resin. Every closable part should have soft rubber sealing, for example O-ring or custom sealing made from mold with silicone caulk.

In my testing, the model didn't resist water pressure deeper than 10 meters.

Always test the model empty before putting electronics inside!

Don't forget to check my article: https://blog.prusaprinters.org/watertight-3d-pr…ing-part-2_53638/