2020 Door Latch

This should be compatible with typical Clicky-Clack Fridge Door setups using 3mm weather stripping while also being compatible with thick insulation panels.

It will not last as forever but it's small and easy to repair if it looses its teeth.

It will leave plastic on the front of your frame that easily wipes off.

It will probably take two hands to open and close. I partially open the top latch then bottom latch with door held shut. I close with one hand holding door shut and in position with another locking the latches using the bridge and equal pressure.

It could be better, but it doesn't need to be better.

Bill of Materials

• 2x M3x25
• 2x M3 Roll in nuts
• 2x M3-5x1mm washer - or a stack to get near 1mm
• 4x M3x10-14mm - holes are tapped beyond the heatset
• 4x M3x4x5 heatsets

Print Specs

Parts are oriented as they should be printed.

• 0.4 nozzle
• 0.25 layers
• 4 walls
• 5 tops/bottoms
• 40% infill