My Sonic pad mount. Feel free to use or modify.

Mount Sonic pad on the top of the printer frame may cause some vibration during the print (mine doesn't – 150mm/s)

There are 2 printer bracket options. (A) uses T-nut. (B) uses bolts below the alu profile – caution and check when Z axis is in upper position, there can be a collision.

Because there are 2 original Sonic pad bolts only I used another 2 set screws to fix clamps (I could not use bolt because original bolt has non standard thread). Tighten them gently and you can use them as an option.

Mine is printed from PLA using some supports, infill 20%.

Bill of material:

POS:      PCS:       ITEM:

1             1             Nut DIN 439 B - M8 - ZN

2             6             Nut DIN 934 - M3 - ZN

3             6             Washer DIN 7980 - 3 - ZN

4             1             Bolt DIN 933 - M8x45 - ZN

5             2             Nut DIN 934 - M4 - ZN

6             2             Bolt DIN 913 - M4x10 - ZN

7             4             Bolt DIN 912 - M3x25 - ZN

8             2             Bolt DIN 912 - M3x30 - ZN

9             1             Washer DIN 7980 - 5 - ZN

10          1             Bolt DIN 912 - M5x12 - ZN

11          1             T-nut M5             

12          1             Printer bracket A              

13          1             Printer bracket B              

14          1             Beam     

15          1             Clamp L 

16          1             Clamp R               

17          2             Original SP screw             

18          1             Knob