Box for a DPH3206 power supply.

It has several input options, input and output fuses, and several output options as well.

Designed so it doesn't require supports, printed face down all angles are 45 degrees or less.

I've supplied the 2 STEP files so it's easy to cut up (close up) the different holes if you want to use different input/output plugs, remove the fuses, etc.

I've had it for a while holds up well in PLA, power supply doesn't seem to heat up enough to hurt it.

Close the back panel with four screws, mount the board with another set of 4, the front panel just clips on.

The backplate on the photo I had forgotten to round the corners :(

Wire the Input on the back to the button, from the button to the input fuse, from the fuse to the board.

Wire the output from the board to the output fuse, from the fuse to the outputs.