really loved this design as I'm getting back into soldering and was tired of trying to balance everything in place to get a good joint made. Wasn't until after I printed everything out that I realized how thin my desk was and the clamp wouldn't fit. So, I threw together a little spacer to make it fit my thinner desktop.

I managed to make this with PLA but it was a bit laborious to get everything to snap together. Also used a torch to heat the end and get the Alligator clamp in.

non printables:

the alligator clips (this was made to fit the ones without the round crimp connection.)

M2*4 screw or bolt

Print Settings

Printer Brand:

Anycubic

Printer: 

Kobra

Rafts:

No

Supports: 

Yes

Infill:

35%

Filament:

Overture PLA+ 

Category: 3D Printing