Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 2.2mm

Filaments Used:

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Orange Transmission Distance: 5

PLA BambuLab Basic Yellow Transmission Distance: 6

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Gray Transmission Distance: 2

PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 7 unique filaments. Substitute as needed.

Swap Instructions:

Start with Red

At layer #9 (0.8mm) swap to Orange

At layer #12 (1.04mm) swap to Yellow

At layer #17 (1.44mm) swap to Black

At layer #19 (1.6mm) swap to Blue Gray

At layer #20 (1.68mm) swap to Gray

At layer #24 (2mm) swap to Jade White for the rest.