Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can adjust the X and Y but Z must remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 2.2mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Blue Gray Transmission Distance: 3

PLA BambuLab Basic Jade White Transmission Distance: 5

PLA BambuLab Basic BambuLab Green Transmission Distance: 2

PLA BambuLab Basic Yellow Transmission Distance: 6

This print uses 5 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #8 (0.72mm) swap to Blue Gray

At layer #10 (0.88mm) swap to Jade White

At layer #16 (1.36mm) swap to BambuLab Green

At layer #20 (1.68mm) swap to Yellow for the rest.