Articulated picam camera mount I created because I didn't like the stock one included with this printer (Kodak Portrait).

For assembly there's some additional hardware required:

• 1 countersunk m4 screw, of any length, for mounting wherever you want to mount your camera
• 2x m3 nuts
• 2x m3 40mm countersunk screws for articulation axles. 35mm should work too with a bit of manual convincing

Assembly needs to be done in certain order, otherwise it's impossible to assemble:

1. mount the frame mount (square piece with hole in the middle) to whatever you want to mount the camera to
2. join mid joint (c-shaped) and camera mount with one of the m3 screws (through the joint, note the countersink) and nut
3. insert CSI tape into your camera module
4. insert camera module into the camera mount, CSI tape pointing *outside*
5. finally join the c-joint to the frame mount

Included CAD files in case you want to modify the design.