Derived from NathanSquire67's Low Poly DireWolf
http://www.thingiverse.com/thing:358837

My Son asked me to print this for him but after 2 attempts the tail would not stay attached to the bed while printing and the print failed.
Im using cura with supports support but the tail did not have any support to keep it still till it was joined to the main body of the model.
So I imported it into freecad and added a little support to the tail.

Freecad files included

I printed this in white abs on a prusa i2 with .5mm nozzle and .125 layers and 4 perimeters. Nozzle 230deg, bed 94deg on kapton tape.

Be vary careful when removing support material as the legs znd base of tail are very thin and easy to break.