Tagline: A cool mod no proud Ender-2 printer owner should be without! :)

A short video of 2nd process being printed: https://www.youtube.com/watch?v=lwOmZVP7mz4

Creality

CR-10

Doesn't Matter

Yes

0.2

15%

This can be printed with a single color/process (and then later painted, if desired), but I sliced it as a multi-process job (as I never tried it before), so will offer here my (S3D) settings if you wanted to go down that road.

Position:
X Offset: 37.21 mm
Y Offset: 71.00 mm
Z Offset: 8.00 mm

Scaling:
Scale: 100%

Rotation: 0 deg (all axes)

Processes:
Process1: hex nut cap (and a small part of "mane" from the head)

• Advanced tab / Layer Modifications / Stop printing at height: 8.80

Process2: dragon head

• Advanced tab / Layer Modifications / Start printing at height: 8.80

Supports are needed (sparsely) under the cap, but not from the outside.

Orientational time and costs:
Build time: 0 hours 23 minutes
Filament length: 1531.4 mm
Plastic weight: 4.60 g (0.01 lb)
Material cost: 0.14

• measured and drew the hex nut cap in F360
• added a circular background (as a head motif would look better on it than on hex)
• extruded the head from a simplified logo version I captured from the device boot screen (see original Thing / Remixed From for details)