This is a slip in flashlight holder for the Honeycomb Storage Wall.  There are two files:

1. one that slips right into the honeycomb itself (which is shown in the pic) called “flashlight_holder_slip-in_big_insert.stl”
2. and another that will slip in to the “empty” or hollow inserts titled “flashlight_holder_slip-in_small_insert.stl”

The gap is 30mm which was perfect to fit around my flashlight handle easily but catch the top part so it hangs there securely but is easy to grab and put away!

they're flat on top so just flip the model to that side and print without any supports (I suppose it could be the bottom too, I guess you get to choose! )

• 0.2 mm layer height
• PLA
• no supports/raft/brim needed