To suit ANY lawnmower with Ø22.4 handlebars, M6 nut and bolt required.
You will need to print both stl files, ( mower-pull_handle.stl and mower_pull_handlepart 2.stl )

This was made for my fathers Victa lawnmower, fitted with a Briggs & Stratton 550EX engine, it has a long start cord that's well suited to this adaptation.

I have a Masport with high mount starter, and when my father tried it once, he wished he had the same on his mower to take some strain off his lower back :)

Printed in ABS 100% infill

Solidworks model available in downloads so you can remix or adjust to suit the correct Diameter of your handlebars, or adjust your bolt/nut size. If you require a specific file format, or If you don't have access to a CAD/modeling program and need a specific size, message and I can assist.

Up

Up Plus

Yes

Yes

0.10

Solid

Printed vertically as shown in image, as the upper side where the pull handle rests was the area I wanted the best finish with no support marks.