This is a remix of the Echo Dot 3rd Gen Wall Socket Mount by @Cerelain and @gohabster ... This is a remix of gohabster 's remix.

The purpose of the remix was to allow for the AU/NZ power adapter to work with the @gohabster original cradle the AU/NZ power adapter is 54mm x 54mm. in turn this adapter doesnt fit with the first design. I also decided to move the socket position up higher on this and added a circular cutout at the back so if using this on a double vertical power point, you have use of that.

Bear in mind the cutout is only for a plug that comes straight out of the wall not a plug that has an angle tail to the plug. this would never work. I have included gohabster original cradle.

please note:

I have limited drawing experience
and did not taper the adapter socket to suit the taper on the adapter. but i have had no trouble with this slipping off the part

Creality

CR-10

No

No

0.2

10%

a 10mm brim was used

made with the following programs simplify3d, vetric v carve,123d