I need to print a new spool holder due to some filament I had didn't fit on the original Ender 5 Holder due to the lip it has at the end.

So i measured the original including the slot for the tightening nut and printed it out without the lip. yes I could of cut the lip off but wheres the fun in that!

I printed in the orientation of the slotted end on the build plate

I printed with standard supports in Cura, when I didn't there was a lot of dropped lines in the slots.

Print instructions

Unassociated tags: Ender 5

Category: 3D Printer Parts Print Settings

Printer Brand: Creality

Printer: Ender 5

Rafts: No

Supports: Yes

Infill: 10

Filament: Ender 5 PLA White