Remix of the needle file holder by noxi to accommodate 6 files instead of 5.
Moved up the snap connector so that there is a bigger surface on the bed, should stick better.
Slightly fixed some geometry issues.

I needed 6 slots for my needle file set so i made this.

Printed in PLA+, 0.2 layer height, 15% infill, 3 walls.

To install you also need a regular multiboard snap.

Rubber hammer helps getting it installed ;)

Update 20/07/2024:

Added an alternative version that supports larger/thicker files up to 6mm thick.

The default is 4mm.