This stand helps to keep your waffles separated and lets them become crusty.

I recommend PETG because it's more heat resistant than PLA. For 12 holders you need a 6mm threaded rod with a length of 22,8mm. I used 18mm MDF for the base (diameter 13cm) and painted it black. For holding the rod in the base I drilled a 5mm hole, cutted a M6 thread, screwed the rod in and countered it using a M6 nut. The holders are fastened with two M6 nuts on the upper end. The nuts are covered with caps. Three felt gliders at the bottom avoid scratches on the table.

Robo 3D

R1 ABS + PLA Model

No

No

0.3mm