Hello!

I decided to design a wallet that would only be a single print and not require any glue.

It works with a tight toleranced zipper on both sides, and a clamping closing mechanism at the top.

If one chooses to change the filament color half way through the print, one can get really cool color combinations!

Next week i'll release a coin purse and a smaller wallet.

The week after that ill release an "inside out" version of all the wallets that should give a really nice look from the outside.

Please leave opinions and design change requests in the comments!

Check out my social media for sneak peaks and memes: https://www.youtube.com/user/a09a21a https://www.facebook.com/SunShine13337/ https://www.instagram.com/sunshine_turbo

Update 14.11.2018:

-New sizes released! -Smallest, small, and medium; (https://www.thingiverse.com/thing:3216321)

-Video on how to assemble released: https://www.youtube.com/watch?v=2a0T6L4gTCs

-Removed Prototype from the files, since its now available as a full release in the link posted above.

Update 03.11.2018:

• WooHoo! BOW 10/21-10/27! Thank you to everyone liking and enjoying this model.
• Sadly i had to go out of town this week and i did not have the possibility to finish and validate the "Lighter pouch" and smaller wallet design.

However, to drench the thirst of people wanting a smaller wallet, I have uploaded a PROTOTYPE Lighter Pouch! This model has not yet been printed by me, but should be 100% printable and should go together without issues. The prototype might have issues with the closing mechanism, (this has been observed in earlier prototypes). If you choose to print the prototype, posting results would be appreciated, and improvements will be implemented asap. The Prototype design has thicker linkages, and more flexible locking mechanism.

For people wanting a refined design, stay tuned until next week!

Update 24.12.2018

Check out Caedo's Zipper sizer tool to be able to easily dial in the correct amount of "Horizontal expansion compensation" / "X-Y compensation"! :https://www.thingiverse.com/thing:3311958

Print Settings

Printer:

Ender 3

Rafts:

Supports:

No

Resolution:

Infill:

20%

Notes: