Parrot Bird Toy
Stark Society
AIで類似品を検索
印刷プロファイル(0)
モデルファイル(0)
1
1
0
公開日時:2026-01-16 15:23:38
4
4
110説明
タグ
モデルソース
レビュー(0)
This is a bird toy SPECIFICALLY DESIGNED FOR PARAKEETS, PARROTLETS AND COCKATEILS. Anything larger or stronger than a Sun Conure or even a Green Cheek Conure would easily be able to break it and then this toy could become a hazard for your bird.
I would recommend printing on its side like the way it is already using tree supports with a 0 percent support density. This will allow for easy removal of the support from the clips. Also please do not use any paint or glue on it as this is extremely dangerous for the bird. It is meant to be printed in one piece for a reason. Please do not scale up or down
This toy was specifically designed for cages with either a 0.5 or 0.75 inch bar spacing, as the clips are spaced 1.5 inches apart. and are 0.4 inches thick.
Print Settings
Printer Brand:
Anycubic
Printer:
Large Size Chiron
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
Any
Filament: Any PLA or PETG (NO ABS OR RESIN EVER) Any Post-Printing =============
Set up
Please be diligent in removing as much support as possible as it can be dangerous if your bird ingests it. It should be able to rotate as soon as it comes off the printer, but if it doesn't, check to see if there is any support in the gap between the rod and hole in the arms that the rod is in. Once all of the support is removed, put seed (millet works best unless you have a funnel) in the egg via the gap and put it in your bird's cage. They might not like it at first but putting seeds in the tray and showing them how it works may help. Good Luck and i hope your bird likes it!
タグ
モデルソース
オリジナルリンク: 詳細を見る
CC-BY