NOTE: This solution is intended to be used with one or more manufactured products.

BrookTrout's description included the observation that he probably would not have used Sorbothane if he hadn't had some on hand already. When I saw that, I started looking for a relatively cheap way to get Sorbothane in a configuration that could be used for the FlashForge Creator Pro. I found a set of four 1.5 inch hemispheres by Isolatit® with a durometer rating of 70 available online for under $16. I've read conflicting values for the capacity of these hemispheres, but they should be able to support up to 14 lbs. each, and should suffice well for the Creator Pro. If you want to take extreme measures to minimize vibrations when printing using a FlashForge Creator Pro, this may provide a way to do it.

You'll need four of whatever configuration you choose, one for each corner. If your model has feet, you'll need to make a choice between the foot chock items.

These will need to be printed with supports, but their removal doesn't have to be meticulous, rough surfaces are OK.

FlashForge

Creator Pro

Doesn't Matter

Yes

.2 mm

15%