I've remixed this great print from JP3DArt that helps the PTFE tube from rubbing on the lid.

1 - I added tongue and groove joints to assemble it all together.

2 - I raised the PTFE tube entrance in the back to allow it to sit on top of the cable chain and fixed one of the arrows that was falling apart after print.

3 - I cut out some slots where the cover has the protruded grab handles so as not to deform the lid or the riser over time.

You need to print 1 part C with supports, 1 part B without supports, 2 part A without supports.

Place on slicer as in picture for best alignment of joints.

Please don't forget to leave a like, Thanks!