Post a make if you print this! :) Seeing our creations out in the wild is inspirational knowing it's helping other folks and encourages creators to put more out there.

Needed a velcro anchor. Designed these and mount with 1/2" #6 wood screws and https://www.amazon.com/gp/product/B08BLCZDYL/ straps.

Print a batch of them. In Prusa slicer you can right click the object and then 'Set number of instances' to whatever like 9. Then at the top of the window, click the 'arrange icon' which looks like three boxes in a single box to lay it out nicely on your print sheet.

The strap opening is 4.7mm x 15mm.

These are pretty sturdy little brackets for cable management.

Orient when printing so the bridging is along the x axis.  On my MK3s this ensured the cleanest bridging.

I use PETG and print on the higher end of the temp range for max adhesion between layers.
Prints without support.

3 perimeters

240C first layer then 230C for every layer after that helped create good looking bridging while being high enough to ensure solid layer adhesion.

Category: Household