This is a remix of one of my own designs, Cat stretch.

I reduced the cat mesh to a lower poly count, and then copy rotated them into 3 positions forming a circle, and then rested a nice sized (almost 8" in diameter) dish balanced between their tail and nose. This model should scale well, should it not fit on your printer bed.

Edit: Added separate files for base and bowl for two color printing. Just align both origins if your slicer has that provision and they will be perfect.

*Update 10-25-2020* Added cats with base to allow for printing a two color catstretch candy bowl on a single extruder printer (separately).

Print Settings

Printer Brand:

LulzBot

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

.2mm

Infill:

Notes:

I have not printed this yet, but shouldn't be too bad. Support the cat chin, her one front paw, some of her belly, and the flat and lower part of the dish. You might consider brim for the cat's feet or a raft.rnrnAs always I recommend with this partial scan to drop the model about .4mm into the bed prior to slicing to improve bed adhesion. The slicer will ignore what is below the bed and make a perfectly flat surface to adhere to the bed.rnrnUse more shells if you want the bowl to be water tight.

Category: Decor