Paying homage to a nice mounting system I found while hunting on Amazon. The Koala Mount 2.0 (http://a.co/d/7R21tyY) is a great design with a lot of neat features. Uses the large 3M Command strips or screws. Note the slot at the bottom is for tucking the end of the Command strip in. There is also a channel and hook for holding a USB cable in place.

Print two, one mirrored. You can also print four so that you can't remove the device.

Print with the right side in the STL preview to the bed. You will need a bit of support for the hook.

Print Settings

Rafts:

Doesn't Matter

Supports:

Category: Organization