Update  -  2/21/25

• Scaled the eye down slightly so it is an easier fit
• Changed the tolerance of the guns to be looser

Print Settings

• .1mm - .2mm layers
• I recommend 3 wall loops
• I used PETG for the black pieces so the hinges don't get loose
• TPU wires

Post Processing

• Inside the leg joint will sag a little from bridging. This makes the joints stiffer, but may need slight clean up.
• Some of the holes for the wires might need drilled out a tiny bit. I just used my side cutters to widen them a bit.

Assembly

• No Glue Required - Everything has very tight tolerances
• Just follow the picture
• Make sure you put the leg together right.. I included a cross section. The leg should be able to bend like the pictures
• Pliers may be required for some steps. Especially putting the clip in the head and pushing in the eye
• If you are still confused on the assembly you can view it in blender

Blender File included

• Feel free to use this any way you want.
• There are three different scenes in the project.