Modelled off a Red Back Spider, this easy to print spider is perfect to freak out that loved one of yours.

This guys legs are pretty thin, so use a smaller nozzle for better results. The spider scales well and can be printed bigger and scarier!

I shaped the legs after printing using boiling water.

Shape the legs to get the spider more realistic!

I achieve this by pouring boiling water into a shallow dish about 1cm deep, then dipping the legs in until soft, then being quick to bend them before they set in place.

It can be tricky and be careful not to burn yourself, do two legs at a time. If you mess up bad you can 'crunch' up the spider to make a 'dead one'.

The thinnest parts at the end of the legs will break off if you bend them cold.

If you have a small heat gun, you can use that too!

Suggestions and tips welcome!

Enjoy!