This is a 3D-printable case for the Amazon Dash button. It's designed to be used either with the sticky pad included (and used to stick it to the inside back of the case) or you will need to use a mm thick spacer/foam pad to hold it in place. The back holds in place purely with friction as long as you don't take it off and put it on too many times. I left a bit of additional space around the outside of the dash to allow for shrinkage of different printers, so if the dash isn't stuck in with double-sided tape or similar it will rattle around.

It's ideal to stick onto a wall etc next to whatever you want to control/order. I use alternate versions at home that can hold multiple Dash buttons (see remixes) where I've cut an icon for whatever it controls into the case as I don't use them to actually order things from Amazon, but to talk to a Raspberry Pi listening for the broadcast when they connect to my network!

I created it in Solidworks and included those files as well as the STLs for printing. The case is 3.2mm thick as I found that any thinner with my printer with it's 0.4mm nozzle the inside and outside of the wall separate.

DeltaWASP 2040

No

No

Print however you like with whatever quality. The higher the better. It's designed to be printed with no supports/raft but you would have to print in the orientation it's shown in the first photo to do this, but you MAY get some issues with the fillet depending on your printer (I haven't). I've also printed the other way up using grid supports autocreated in Cura with no issues.